Garage Door Seal Replacement in Mona, UT | Garage Door USA
from $79
Garage Door Garage Door Seal Replacement Mona, UT
Bottom astragal and U-channel seal replacement. We carry T-style, P-style, and bulb seals to fit any retainer, so water, dust, leaves, and rodents stop creeping under your door.
Homeowners across Mona and the surrounding area call us for garage door seal replacement because we know Mona. The common drivers locally are dust-fouled tracks that bind and throw the door off level, heat-warped panels on west-facing steel doors, overheated opener motors straining against binding doors, and loosened hardware from constant expansion and contraction — and we fix the cause, not just the symptom.
Ask any Mona tech and they'll tell you the climate decides what fails. Dry conditions year-round with big seasonal swings — scorching summers, cold winters, and frequent wind-driven dust brings intense UV that embrittles rubber gaskets and bottom seals, winter cold snaps that stiffen springs and grease, and fine wind-borne dust that grinds down track rollers, year after year.
Run down the service log for Mona and the same repairs repeat: dust-fouled tracks that bind and throw the door off level, heat-warped panels on west-facing steel doors, overheated opener motors straining against binding doors, and loosened hardware from constant expansion and contraction. We carry every part needed to close them out in one trip.
Bottom seal replacement is the highest-volume seal job we do — bottom astragals wear out faster than the side jamb or top header seals because they contact the floor every close cycle. The seal compresses, deforms, hardens under UV, and eventually tears or cracks. A failed bottom seal lets water, dust, leaves, insects, and small rodents under the door. The fix is straightforward and quick: remove the old seal, slide a new one into the retainer (or replace the retainer if it's also worn), trim to length, and verify a tight close.
We carry T-style, P-style, and bulb-profile astragals to fit any retainer. The retainer (U-channel) is the aluminum or PVC track that holds the seal — if the retainer itself is cracked or pulling away from the bottom panel, we replace it during the same visit. Stock profiles cover 95% of doors; obscure or vintage doors may need a special-order astragal.
Fast service for stock profiles is standard. Most visits take 45–60 minutes including a quick check of the side and header seals and a confirmation of the bottom-to-floor gap with the new seal compressed.
Worn or compressed seal lets daylight through. Replacement restores the seal.
Water enters during rain
Bottom seal failure is the most common cause of garage water intrusion during heavy rain.
Leaves or debris under door
Wind blows debris under failed seals. Restored seal stops the inflow.
Insects or rodents entering
Even small gaps let pests through. A continuous seal stops them.
Seal visibly cracked, torn, or chunked
Visible damage means the seal is functionally compromised even if the gap looks small.
Common causes & what we fix
UV degradation
intense sun hardens vinyl and rubber seals over 5–8 years. Hardened seals crack and tear.
Floor contact wear
The seal compresses and abrades against the floor every close cycle. Wear is cumulative over years.
Concrete heave or settlement
Floor changes shape with foundation movement. Old seal can't compensate; new seal with potential threshold kit can.
Pest damage
Rodents chew through seals to enter. Once chewed, seal must be replaced — repair isn't viable.
Retainer corrosion or cracking
Aluminum retainers corrode at the floor contact line; PVC retainers crack with age. Retainer replacement extends seal life.
Our process
1
Call or schedule online. Line up garage door seal replacement for Mona on a 2-hour window. We answer fast and send a confirmation — tech name, tech photo — inside five minutes.
2
On-site diagnosis. Before any garage door seal replacement work, we walk you through the on-site diagnosis — free for most repairs, $39 on minor service calls and credited back if you go ahead.
3
Flat-rate quote. You get a flat-rate garage door seal replacement quote in writing before any work begins — no hourly creep, no upsell pressure, because our techs are salaried, not commissioned.
4
Same-visit fix. Garage door seal replacement in Mona is typically one-and-done, backed by a 96% first-call fix rate. We test the door with you and clean up fully before we leave.
How much does garage door seal replacement cost in Mona, UT?
Garage Door Seal Replacement in Mona is priced from $79, flat-rate and in writing before any work. We'll tell you honestly when a repair beats a replacement, so you're not paying for garage door seal replacement you don't actually need. We keep garage door seal replacement affordable across Mona, UT — one flat number quoted up front, the same one you pay at the end.
Garage Door Seal Replacement the United States starts at from $79, with the full garage door seal replacement price written down and locked before we start — there's no hourly meter and nothing bolted on later. We take 10% off labor for seniors (65+) and military, and jobs over $1,500 qualify for 0% APR Synchrony financing for 12 months, approved fast with no prepayment penalty.
Why homeowners in Mona, UT choose us for garage door seal replacement
The Mona homeowners who book garage door seal replacement with us value the same things — honest scope, parts that hold up in Utah's semi-arid interior, and a quote that doesn't move once we start. Family-owned since 1974. Looking for a garage door seal replacement company in Mona, UT? That's exactly what we are — local, licensed, and accountable to Juab County.
We guarantee garage door seal replacement workmanship for 10 years, held separate from whatever warranty the manufacturer puts on the parts. If our garage door seal replacement fails on the install, we come back and correct it free for a decade. Springs rated for 30,000 cycles carry a lifetime warranty for the original homeowner; everything else is covered 1–5 years by item.
We keep garage door seal replacement honest two ways — honest sizing and honest scope. There's no up-sell because the techs are salaried, not commissioned, and the diagnostic shows you precisely what we see, parts in good shape included. Repair or replace, we recommend whichever wins long-term, and the garage door seal replacement quote is flat-rate, written, and valid 30 days.
Areas we serve for garage door seal replacement
We provide garage door seal replacement throughout Mona, UT and the surrounding Juab County area. Serving Mona and surrounding neighborhoods.
Our garage door seal replacement routing keeps dispatch short across Juab County — Mona lies within Juab County, in Utah. Mona and Nephi, Rocky Ridge, Santaquin, and Genola are all on the daily loop.
Whether you're in Mona or nearby Nephi, Rocky Ridge, Santaquin, and Genola, our garage door seal replacement dispatch routes the closest stocked truck — that's the 90-minute average across Juab County. Need garage door seal replacement near 84645? It's on the daily Juab County loop, dispatched to the closest stocked truck.
Garage Door Seal Replacement near you in Mona, UT
When Mona homeowners look for garage door seal replacement near them, they want someone close, fast, and accountable. That's us: CSLB-licensed, on-site in about 90 minutes, dispatched from the nearest stocked truck in Juab County.
Mona is part of our greater Provo, UT metro service area.
We cover ZIP codes 84645 and the surrounding area. Reach times for garage door seal replacement in Mona vary by traffic and time of day; we'll quote an accurate ETA when you call. Our dispatch line routes straight to an on-call technician — no voicemail between you and the person solving the problem. "Local garage door seal replacement near me" in Mona should mean a tech who already works your street — with us it does.
Frequently asked about garage door seal replacement
Top questions homeowners searching for Garage Door Seal Replacement near me ask us:
Mona sits in dry conditions year-round with big seasonal swings — scorching summers, cold winters, and frequent wind-driven dust. That is hard on a door — intense UV that embrittles rubber gaskets and bottom seals, winter cold snaps that stiffen springs and grease, and fine wind-borne dust that grinds down track rollers all accelerate wear on springs, seals, and openers, so the failures we see most here are dust-fouled tracks that bind and throw the door off level, heat-warped panels on west-facing steel doors, overheated opener motors straining against binding doors, and loosened hardware from constant expansion and contraction. We size springs and seals for Utah's semi-arid interior conditions rather than a generic catalog spec.
The call we get most in Mona is dust-fouled tracks that bind and throw the door off level. Mona has mainly suburban houses with attached two-car garages, mixed with some older central-neighborhood homes, so heat-warped panels on west-facing steel doors turns up often too. We carry the common parts on the truck for a single-visit fix.
Yes — threshold kits sit on the floor and create a positive bottom seal even on uneven floors or where bottom astragal alone isn't enough. Installed flat-rate, quoted before we start.
Up to ~1 inch of floor variation — yes. Bulb seals compress more than T-style and handle more variation. For severe floor unevenness, threshold kit is the better solution.
5–8 years for bottom seals in intense sun. Sheltered or shaded doors get 10+ years. Side and header seals last longer.
Bottom seal only: 30–45 minutes. With retainer replacement: 60–75 minutes. With side and header seals: 90–120 minutes.